HOME . SHOP . TOOLS . PROJECTS

Projects:  Unisaw Outfeed Table
January 2007

I built this folding, modular outfeed table to support multiple types of work on my unisaw.  When fully set up, the table measures 51" wide by 48" deep, with the depth greatly extendable using portable stands for the outermost third section.  The panels are made of 3/4" melamine with cherry trim.  The edge trim is 1 1/2" wide and the support aprons are 2" deep.
Section 1:  This section is fixed in place, attached to the saw's rear rail.  Miter slots are cut for runners.  The panel is 15" deep.
Outfeed Section 1.1 Outfeed Section 1.2
Outfeed Section 1.3 Outfeed Section 1.4
Section 2:  This section is attached with a piano hinge and folds up or down.  It is supported on the outer side with legs attached with folding latches.  The panel is 18" deep.
Outfeed Section 2.1 Outfeed Section 2.2
Outfeed Section 2.3 Outfeed Section 2.4
Outfeed Section 2.5
Section 3:  This section is simply one additional panel that sits free on top of adjustable stands.  The panel is 15" deep.
Outfeed Section 3.1 Outfeed Section 3.2
Outfeed Section 3.3 Outfeed Section 3.4


Back to top.